The passenger front seat E-Z entry system has the adjuster release lever located on the outer adjuster. The inner adjuster acts as a slave unit. Perform the following steps in order to activate the inner adjuster:

1. Lift the seat back latch.
2. Move the seat back forward.

When you enter the rear seating area, the forward movement of the seat back trips a cable. The cable releases a lock bar on the adjuster. This action allows the seat to move forward in order to provide more room for passenger entry into the rear seat.

Apply rearward pressure to the top of the seat back in order to return the seat to the original position. The seat moves rearward until the E-Z entry lock feature engages.

1. Position the front bucket seat forward or rearward in order to gain access to the seat adjuster nuts (3).
2. Remove the seat adjuster stud covers (2) and seat adjuster nuts (3).
3. Disconnect the seat belt wire harness if required.
4. Remove the front bucket seat (1) from the vehicle.

1. Install the front bucket seat (1) into the vehicle.
2. Connect the seat belt wire harness if required.
3. Position the front bucket seat fully forward to gain access to the seat adjuster rear nuts (3).
4. Install the front bucket seat rear adjuster nuts (3).

Hand tighten the nuts.

5. Adjust the seat fully rearward.
6. Verify both lock bars are engaged in the most forward adjustment in the same notch on both of the seat adjusters.

Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.

7. Install the front bucket seat front adjuster nuts (3).

Tighten
Tighten the nuts to 20 N·m (21 lb ft).

8. Adjust the front bucket seat to the full forward position and tighten the rear adjuster nuts.

Tighten
Tighten the nuts to 20 N·m (21 lb ft).

9. Install the seat adjuster stud covers (2).
10. Check the front bucket seat for proper operation.