GM Service Manual Online
For 1990-2009 cars only
Makes 🢒 Pontiac 🢒 2005 🢒 Sunfire 🢒 Body 🢒 Roof 🢒 Sunroof Guide Replacement

Removal Procedure
  1. Close the sunroof.
  2. Remove the sunroof window. Refer to Sunroof Window Replacement .
  3. Remove the sunroof module assembly. Refer to Sunroof Module Assembly Replacement .

    4. Object Number: 280687 Size: MH
  4. Remove the sunshade panel (3). Refer to Sunroof Sunshade Replacement .
  5. Remove the sunroof motor/actuator (7). Refer to Sunroof Motor/Actuator Replacement .
  6. Remove the rivets from the sunroof tube retainers, which are located on the motor bracket.
  7. Remove the sunroof track screws.
  8. Remove the tie wraps holding the drive tube (6) to the retaining tube (5).
  9. Pull the cable out of the plastic return tube.
  10. Remove the sunroof track and lifter arm assembly by pushing the track assembly inwards to loosen (9).
  11. Remove the sunroof drive tube retainer (10) from the end of the track and the copper drive tube.

Installation Procedure
  1. Feed the sunroof drive cable through the copper drive tube.
  2. Install the sunroof drive tube retainer with the copper drive tube into the track end.
  3. Install the sunroof track and lifter arm assembly into the module frame.
  4. Feed the sunroof drive cable through the plastic return tube.
  5. Align the track parallel to each other with 666 mm between the left and right track at the front and rear of the track.

    6. Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.

  6. Install the sunroof track screws.

    7. Tighten
    Tighten the screws to 4 N·m (35 lb in).


    Object Number: 280687 Size: MH
  7. Install the sunroof cable wear plate (14).
  8. Install the sunroof tube retainers to the motor bracket (10).
  9. Install the rivet to the sunroof tube retainer.
  10. Verify that the forward glass adjustment screw hole in the lifter arm is aligned with the small hole in the cable cam assembly. If required, push the lifter arm or the cable cam forward to align the two holes.
  11. Install the sunroof motor/actuator (7). Refer to Sunroof Motor/Actuator Replacement .
  12. Tie wrap the drive (6) and return tubes (5) together.
  13. Install the sunroof module assembly. Refer to Sunroof Module Assembly Replacement .
  14. Install the sunroof window. Refer to Sunroof Window Replacement .
  15. Install the sunshade panel. Refer to Sunroof Sunshade Replacement .