This bulletin cancels and replaces bulletin 90-6-15 issued 12/89. This bulletin is being revised to specify the 3.1L engine.
SERVICE MANUAL UPDATE
Use this procedure when servicing the oil filter adapter on the following vehicles with the 3.1L engine.
Remove or Disconnect
- Raise vehicle and suitably support, refer to GENERAL INFORMATION (SECTION OA)
1. Oil filter
2. Oil pressure sensor wires
3. Oil pressure sensor
4. Connector
5. Adapter and gasket
Clean
Oil filter adapter and engine block mating surface
Install or Connect
1. Gasket
2. Adapter
3. Connector
Tighten
Connector to 67 N.m (50 lb.ft.)
4. Oil pressure sensor
5. Oil Pressure sensor wires
6. Oil filter
Lower vehicle
Check oil level and fill to proper level if necessary.
Refer to MAINTENANCE AND LUBRICATION (SECTION OB).
6000 AND GRAND PRIX MODELS
Oil Filter Adapter
Refer to Figure 1
Remove or Disconnect
Raise vehicle and suitably support, refer to GENERAL INFORMATION (SECTION OA).
1. Oil filter
2. Connector
3. Adapter and gasket
Clean
Oil filter adapter and engine block mating surface.
Install or Connect
1. Gasket
2. Adapter
3. Connector
Tighten
Connector to 67 N.m (50 lb. ft.)
4. Oil filter
Lower vehicle
Check oil level and fill to proper level if necessary.
Refer to MAINTENANCE AND LUBRICATION (SECTION OB).
General Motors bulletins are intended for use by professional technicians, not a "do-it-yourselfer". They are written to inform those technicians of conditions that may occur on some vehicles, or to provide information that could assist in the proper service of a vehicle. Properly trained technicians have the equipment, tools, safety instructions and know-how to do a job properly and safely. If a condition is described, do not assume that the bulletin applies to your vehicle, or that your vehicle will have that condition. See a General Motors dealer servicing your brand of General Motors vehicle for information on whether your vehicle may benefit from the information.