Tools Required

J 8614-01 Pinion Flange Holder

1. Lubricate the front seal and the sealing surface of the crankshaft pulley with Chassis Grease GM P/N 1051344 (Canadian P/N 993037) or equivalent.
2. Install the crankshaft pulley onto the crankshaft indexing keyway. Tap into place using a rubber or sand-filled mallet.

Notice: Refer to Fastener Notice in the Preface section.




3. Install the crankshaft pulley retaining bolt using J 8614-01 to prevent crankshaft rotation when tightening the bolt.

Tighten
Tighten the bolt to 118 N·m (87 lb ft).