Removal Procedure
- Remove the manual shift lever from the vehicle. Refer to Manual Selector Replacement .
- Remove the inflatable restraint sensing and diagnostic module (SDM) from the vehicle. Refer to Inflatable Restraint Sensing and Diagnostic Module Replacement in SIR.
- Disconnect the heated oxygen sensor (HO2S) electrical sensor. Refer to Heated Oxygen Sensor 2 Replacement in Engine Controls - 1.8L (LV6).
- Remove the air cleaner assembly from the vehicle. Refer to Air Cleaner Element Replacement in Engine Controls - 1.8L (LV6).
- Raise and suitably support the vehicle. Refer to Lifting and Jacking the Vehicle in General Information.
- Remove the exhaust pipe from the vehicle. Refer to Front Pipe Replacement in Engine Exhaust.
- Remove the front heat shield from the vehicle.
- Remove the cable retaining clip, then disconnect the cable from the bracket.
- Remove the shift select cable from the cable support bracket.
- Remove the 2 nuts then separate the cable from the vehicle.
- Using a screwdriver, disconnect the shift select cable from the bracket.
- Disconnect the shift select cable from the transaxle.
- Lower the vehicle.
- Remove the shift select cable from the vehicle.
- Inspect the shift select cable for kinks, fraying, or excessive wear. Replace as necessary.
Installation Procedure
- Install the shift select cable into the bulkhead from the passenger compartment side.
- Raise and suitably support the vehicle. Refer to Lifting and Jacking the Vehicle in General Information.
- Install the shift select cable into the bracket.
- Install the shift select cable bracket and the 2 retaining nuts.
- Connect the shift select cable to the cable support bracket.
- Install the shift cable into the transaxle bracket, then install the retaining clip.
- Connect the shift select cable to the transaxle, then secure the shift select cable with one lock washer and nut.
- Install the front heat shield on the vehicle.
- Install the front exhaust pipe assembly. Refer to Front Pipe Replacement in Engine Exhaust.
- Lower the vehicle.
- Install the SDM in the vehicle. Refer to Inflatable Restraint Sensing and Diagnostic Module Replacement in SIR.
- Install the manual shift lever in the vehicle. Refer to Manual Selector Replacement .
- Connect the HO2S electrical connector. Refer to Heated Oxygen Sensor 2 Replacement in Engine Controls - 1.8L (LV6).
- Install the air cleaner assembly. Refer to Air Cleaner Element Replacement in Engine Controls - 1.8L (LV6).
- Connect the negative battery cable. Refer to Battery Replacement in Engine Electrical.
- With the ignition switch in the LOCK position and the manual selector in the Park position, attempt to manually push the vehicle. Vehicle should not move.
- Verify that the vehicle CANNOT be driven in the Neutral position
- Verify that the vehicle can be driven in D, 2, and L.
- Verify that reverse gear DOES operate in R.
Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.
Install the select cable grommet retaining bolts.
Tighten
Tighten the retaining bolts to 5 N·m
(43 lb in).
Tighten
Tighten the retaining bolts to 12 N·m
(9 lb ft).
Tighten
Tighten the shift select cable nut to 12 N·m
(106 lb in).
Tighten
Tighten the heat shield bolts to 5 N·m
(44 lb in).
