For 1990-2009 cars only
Removal Procedure
- Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle .
- Remove the rear transaxle mount thru bolt and heat shield.
- Remove the rear transaxle mount to frame bolts.
- Remove the rear transaxle mount.
Installation Procedure
- Install the rear transaxle mount to frame bolts. Hand tighten the bolts.
- Install the rear transaxle mount, heat shield and the thru bolt to the transmission bracket. Hand tighten the bolt.
- Tighten the rear transaxle mount to frame bolts.
- Loosen the front transaxle mount thru bolt but do not remove the bolt.
- Tighten the rear transmission mount thru bolt.
- Tighten the front transmission mount thru bolt.
- Lower the vehicle.
Notice: Refer to Fastener Notice in the Preface section.
Tighten
Tighten the bolts to 60 N·m (44 lb ft).
Important:
| • | Rotate the rear transaxle mount heat shield clockwise until the tab is seated on the mount bracket. |
| • | The front and rear transmission mounts must be allowed to settle with the thru bolts loosened. |
Tighten
Tighten the thru bolt to 100 N·m (74 lb ft).
Tighten
Tighten the thru bolt to 100 N·m (74 lb ft).
