Step | Action | Value(s) | Yes | No |
|---|---|---|---|---|
Connector End View Reference: Engine Control Module Connector End Views in Engine Controls - 3.0L (L81) | ||||
1 | Did you perform the Diagnostic System Check - Vehicle? | -- | Go to Step 2 | Go to Diagnostic System Check - Vehicle in Vehicle DTC Information |
2 |
Does the battery charge indicator remain illuminated? | -- | Go to Step 3 | Go to Testing for Intermittent Conditions and Poor Connections in Wiring Systems |
3 |
Does the voltage measure within the normal operating range? | 12.6-16.0 V | Go to Step 4 | Go to Charging System Test |
4 | With a scan tool, observe the Ignition 1 parameter in the engine control module (ECM) data list. Does the voltage measure within the normal operating range? | 12.6-16.0 V | Go to Step 5 | Go to Charging System Test |
5 | With a scan tool, command the lamp and gages ON and OFF. Does the charge indicator turn ON and OFF with each command? | -- | Go to Step 6 | Go to Step 7 |
6 |
Important: Perform the setup procedure for the ECM. Replace the ECM. Refer to Control Module References in Computer/Integrating Systems for replacement, setup, and programming. Did you complete the replacement? | -- | Go to Step 8 | -- |
7 | Replace the instrument panel cluster (IPC). Refer to Control Module References in Computer/Integrating Systems for replacement, setup, and programming. Did you complete the replacement? | -- | Go to Step 8 | -- |
8 | Operate the system in order to verify the repair. Did you correct the condition? | -- | System OK | Go to Step 2 |
