GM Service Manual Online
For 1990-2009 cars only

Removal Procedure


    Object Number: 881349  Size: SH
  1. Depress center pins inward to release radio/HVAC controller cover push pin fasteners.
  2. Important: Do not push center pins through fasteners.

  3. Remove fasteners and pull radio/HVAC controller cover rearward.
  4. Disconnect traction control/fog lamp/rear defog electrical connector, if equipped.

  5. Object Number: 878767  Size: SH
  6. Rotate center deflectors down.
  7. Place a small flat blade screwdriver between deflectors and pry slightly apart to disengage pivot point.
  8. Remove deflectors.

  9. Object Number: 878772  Size: SH
  10. Use a small flat blade screwdriver to disengage lock tabs on both sides of center outlet housing while pulling housing rearward.
  11. Remove housing.

Installation Procedure


    Object Number: 881354  Size: SH
  1. Install center outlet hosing into opening in I/P retainer. Push in until tabs are flush with sides of housing.
  2. Important: Small pivot pins are in center of housing. Large pivot pins are on sides of housing.

  3. Rotate center outlets down and snap into housing.

  4. Object Number: 881349  Size: SH
  5. Connect traction control/fog lamp/rear defog electrical connector, if equipped.
  6. Install radio/HVAC control cover. Push in at clip locations.
  7. Install push pins and lock.