Instrument Cluster Replacement Left Hand Drive

1. Disable the SIR System.
2. Remove the screws from the DLC connector and steering filler panel.



3. Remove hood release cable from lever.
4. Remove steering column filler panel.



5. Disconnect ignition switch electrical connector at right steering column bolt.
6. Remove steering column bolts and lower column on front seat.



7. Remove fasteners and pull instrument cluster trim bezel rearward at clip locations.
8. Disconnect electrical connector from instrument panel dimmer switch.



9. Remove connector position assurance (CPA) devices and disconnect electrical connectors from instrument panel cluster assembly by squeezing tabs on each side of connector.



10. Remove front and rear instrument panel cluster assembly screws.
11. Remove instrument panel cluster assembly.

1. Install instrument panel cluster assembly.
2. Install and tighten instrument panel cluster assembly screws.



3. Connect electrical connectors to I/P cluster assembly.
4. Install CPA devices.



5. Connect electrical connector to I/P dimmer switch.
6. Install instrument cluster trim bezel. Push in at clip locations.
7. Install push pin fasteners.



8. Raise steering column into position.
9. Install and torque bolts.

Tighten
Tighten bolts to 35 N·m (26 lb ft)

10. Connect ignition switch electrical connector at right steering column bolt.



11. Install hood release cable to lever.



12. Install steering column filler panel and DLC connector.
13. Install and tighten screws.
14. Enable the SIR System.