GM Service Manual Online
For 1990-2009 cars only
Makes 🢒 Buick 🢒 2005 🢒 Allure 🢒 Body 🢒 Doors 🢒 Front Side Door Window Regulator Replacement

Removal Procedure

    Caution: Disconnect the power window switch when working inside the driver door. When operated, the Express Up/Down Feature allows the door window to move very quickly, without stopping, which could cause personal injury.

  1. Remove the front door trim panel. Refer to Front Side Door Trim Panel Replacement .
  2. Remove the front door water deflector. Refer to Front Side Door Water Deflector Replacement .

    3. Notice: To avoid paint damage, protect the area surrounding the part which you are removing or installing.

  3. Apply masking tape to the outer reveal.

    4. Object Number: 1362843 Size: SH
  4. Raise the window far enough in order to gain access through the inner door panel to the window guide retainer clip.
  5. Push inward on the window guide retainer clip locks, lift upward on the window until released from the retaining clip.
  6. Raise the window to the full up position and tape in place.
  7. Disconnect the electrical connector from the power window motor by pulling up on the tab to release it.

    8. Object Number: 1362845 Size: SH
  8. Remove the bolt from the window regulator motor (3).
  9. Remove the nuts (2, 4) from the window regulator studs.
  10. Remove the window regulator and motor through the access opening in the inner door panel.
  11. Remove the power window motor from the window regulator. Refer to Front Side Door Window Regulator Motor Replacement .

Installation Procedure
  1. Install the power window motor to the window regulator. Refer to Front Side Door Window Regulator Motor Replacement .

    2. Object Number: 1362845 Size: SH
  2. Install the window regulator and motor through the access opening in the inner door panel.
  3. Install the nuts (2, 4) to the window regulator studs.
  4. Install the window regulator motor bolts (3).

    5. Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.

  5. Tighten the window regulator bolt and nuts to the door.

    6. Tighten
    Tighten the bolt and nuts to 10 N·m (89 lb in).


    Object Number: 1362843 Size: SH
  6. Connect the electrical connector to the power window motor and push in on the tab to lock in place.
  7. Remove the masking tape.
  8. Lower the window far enough in order to gain access through the inner panel to the window guide retainer to snap the window into the retainer.
  9. Inspect the window for proper operation.
  10. Install the front door water deflector. Refer to Front Side Door Water Deflector Replacement .
  11. Install the front door trim panel. Refer to Front Side Door Trim Panel Replacement .