GM Service Manual Online
For 1990-2009 cars only
Makes 🢒 Buick 🢒 2005 🢒 Allure 🢒 Body 🢒 Doors 🢒 Rear Side Door Window Regulator Replacement

Removal Procedure
  1. Remove the rear door trim panel. Refer to Rear Side Door Trim Panel Replacement in Interior Trim.
  2. Remove the rear door water deflector. Refer to Rear Side Door Water Deflector Replacement .

    3. Notice: To avoid paint damage, protect the area surrounding the part which you are removing or installing.


    Object Number: 1363625 Size: SH
  3. Raise the window far enough in order to gain access through the inner door panel to the window guide retainer clips.
  4. Push inward on the window guide retainer clip locks, lift upward on the window until released from the retaining clip.
  5. Raise the window to the full up position and tape in place.
  6. Disconnect the electrical connector from the power window motor.

    7. Object Number: 1363645 Size: SH
  7. Loosen the bolt to the window regulator motor (2, 3, 4).
  8. Lift the motor free of the retaining slot.
  9. Remove the window regulator and motor from the door.
  10. Remove the power window motor from the window regulator. Refer to Rear Side Door Window Regulator Motor Replacement .

Installation Procedure
  1. Install the power window motor to the window regulator. Refer to Rear Side Door Window Regulator Motor Replacement .

    2. Object Number: 1363645 Size: SH
  2. Install the bolts  (2, 3, 4) to the window regulator and motor.
  3. Position the window regulator and motor into the locating slots of the inner door panel.

    4. Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.

  4. Install the window regulator and motor bolts to the door.

    5. Tighten
    Tighten the bolts to 10 N·m (89 lb in).

  5. Connect the electrical connector to the power window motor.
  6. Remove the masking tape.

    7. Object Number: 1363625 Size: SH
  7. Lower the window far enough in order to gain access through the inner door panel to the window guide retainer clips.
  8. Inspect the window for proper operation.
  9. Install the rear door water deflector. Refer to Rear Side Door Water Deflector Replacement .
  10. Install the rear door trim panel. Refer to Rear Side Door Trim Panel Replacement .