Removal Procedure
- Disconnect the negative battery cable. Refer to
Battery Negative Cable Disconnection and Connection
.
- Remove the 14-way electrical connector from the ignition control module (ICM).
- Disconnect the spark plug wires from the coil assemblies. Before removing the wires, note the position of the wires .
- Remove the ICM nuts (2).
- Remove the ICM (1) from the bracket.
- Remove the ignition coil screws (1).
- Remove the ignition coils (2) from the ICM (3).
Installation Procedure
- Install the ignition coils (2) to the ICM (3).
Notice: Refer to Fastener Notice in the Preface section.
- Install the ignition coil screws (1).
Tighten
Tighten the screws to 4.5 N·m (40 lb in).
- Install the ICM (1) to the bracket.
- Install the ICM nuts (2).
Tighten
Tighten the nuts to 10 N·m (89 lb in).
- Connect the spark plug wires to the ignition coils.
- Install the 14-way electrical connector to the ICM.
Tighten
Tighten the screw to 2.1 N·m (19 lb in).
- Connect the negative battery cable. Refer to
Battery Negative Cable Disconnection and Connection
.