Tools Required

1. Remove the air inlet grille panel. Refer to Air Inlet Grille Panel Replacement in Body Front End.



2. Using the J 39232 , disconnect the wiper transmission from the wiper motor crank arm.



3. Remove the wiper motor crank arm cover.
4. Remove the wiper motor crank arm screw.
5. Remove the wiper motor crank arm from the wiper motor.

1. Position the wiper motor crank arm onto the wiper motor.
2. Measure the gap between wiper motor crank arm and the bracket tab. If the gap is not 4-8 mm (0.157-0.314 in), remove the wiper motor crank arm and repeat installation.

Notice: Refer to Fastener Notice in the Preface section.




3. Install the wiper motor crank arm screw .

Tighten
Tighten the screw to 16 N·m (12 lb ft).

4. Install the wiper motor crank arm cover.



5. Using the J 39529 , install the wiper transmission to the wiper motor crank arm.
6. Install the air inlet grille panel. Refer to Air Inlet Grille Panel Replacement in Body Front End.
7. Operate the windshield wipers and inspect for proper operation.