• | J 36850 Transjel® Lubricant |
• | J 45023 Control Main Filter Wrench |
Caution: The torque converter housing/oil pump cover assembly dry weights are approximately
27 kg (60 lb). To help avoid personal injury and/or property damage:
• Use caution when installing, removing, or moving the converter housing/oil pump cover assembly. • Get help when lifting the converter housing/oil pump cover assembly. • Assistance from a hoist or another person may be required. • Make sure lifting equipment can properly support the converter housing/oil pump cover assembly.
Notice: Transmission
damage may occur if the torque converter housing is forced into position. If tapping
does not cause the torque converter housing to drop into place, then one or more of
the following components may be misaligned:
• Output sun gear • Output sun gear spacer • Seal ring
Notice: Refer to Torque Converter Housing/Low and Reverse Clutch Housing Bolt Size Notice in the Preface section.
Notice: Refer to Fastener Notice in the Preface section.
Tighten
Tighten bolts (1, 2, 3) to 56 N·m (42 lb ft).
Notice: Refer to Component Fastener Tightening Notice in the Preface section.
Notice: Install the short-threaded end of the transmission external oil filter adapter into the converter housing. If the long-threaded end of the filter adapter is installed, the threads of the converter housing will be damaged.
Tighten
Tighten the adapter to 30 N·m (22 lb ft.)
Notice: Turning the transmission external oil filter more than ONE FULL TURN after gasket contact will damage the filter.
Tighten
Tighten the plug to 12 N·m (108 lb in).
Tighten
Tighten the connectors to 25 N·m (19 lb ft).