Removal Procedure
- Turn the ignition OFF.
Important: Do not remove the engine control module (ECM) from the ECM bracket .
Do not remove the ECM redundant ground wire from the ECM.
- Remove the ECM bracket bolts and reposition the ECM bracket in order to provide access.
- Remove the camshaft position (CMP) actuator valve electrical connector.
- Remove the CMP actuator valve bolt.
- Remove the CMP actuator valve.
Installation Procedure
- Install the CMP actuator valve.
Notice: Refer to Fastener Notice in the Preface section.
- Install the CMP actuator valve bolt.
Tighten
Tighten the CMP actuator valve bolt to 10 N·m (89 lb in).
- Install the CMP actuator valve electrical connector.
- Install the ECM bracket with the ECM. Refer to
Engine Control Module Replacement
.