GM Service Manual Online
For 1990-2009 cars only
Makes 🢒 Buick 🢒 2007 🢒 Allure 🢒 Body Systems 🢒 Vehicle Access 🢒 Door Striker Anchor Plate Replacement

Removal Procedure

    Object Number: 794023 Size: SH

    Important: This procedure covers the removal and installation of the front and the rear door strikers.

    It will be necessary to remove the following trim when replacing the front or the rear striker.

    Important: When the striker bolts have been removed, the striker anchor plate will slip down in the door pillar or quarter panel and the trim will need to be removed to gain access.

  1. Remove the rear quarter lower trim. Refer to Quarter Lower Rear Trim Panel Replacement.
  2. Remove the lower center pillar trim. Refer to Center Pillar Lower Trim Panel Replacement.
  3. Mark the position of the striker with a grease pencil.
  4. Remove the screws from the door striker.
  5. Remove the striker (2).

Installation Procedure

    Object Number: 794023 Size: SH
  1. Install the striker (2) to the door opening.

    2. Align the striker to the alignment marks.

    Notice: Refer to Fastener Notice in the Preface section.

  2. Install the screws to the striker.

    3. Tighten
    Tighten the screws to 20 N·m (15 lb ft).

  3. Adjust door striker. Refer to Door Lock Striker Adjustment .
  4. Inspect the door for proper operation.
  5. Install the front or the rear trim if removed.
  6. Install the rear quarter lower trim panel. Refer to Quarter Lower Rear Trim Panel Replacement.
  7. Install the lower center pillar trim. Refer to Center Pillar Lower Trim Panel Replacement.