GM Service Manual Online
For 1990-2009 cars only
Makes 🢒 Buick 🢒 2007 🢒 Allure 🢒 General Information 🢒 General Information 🢒 Stabilizer Shaft Replacement

Removal Procedure
  1. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle .
  2. Remove the tires and wheels. Refer to Tire and Wheel Removal and Installation .

    3. Object Number: 614968 Size: SH
  3. Remove the left and right stabilizer shaft link lower nuts from the stabilizer shaft links (1).

    4. Object Number: 1209600 Size: SH
  4. Remove the clamp bolts from the stabilizer shaft.
  5. Remove the stabilizer shaft from the rear suspension support.

Installation Procedure

    Object Number: 1209600 Size: SH
  1. Install the stabilizer shaft to the rear suspension support.
  2. Install the stabilizer shaft clamps and bolts. Do not tighten the bolts at this time.

    3. Notice: Refer to Fastener Notice in the Preface section.


    Object Number: 614968 Size: SH
  3. Install the right and left stabilizer shaft link nuts (1) to the stabilizer shaft links (2).

    4. Tighten

        • Tighten the stabilizer shaft link nuts to 45 N·m (33 lb ft).
        • Tighten the stabilizer shaft insulator bracket nuts to 51 N·m (38 lb ft).
  4. Install the tires and wheels. Refer to Tire and Wheel Removal and Installation .
  5. Lower the vehicle.