GM Service Manual Online
For 1990-2009 cars only

Removal Procedure

Caution: Use care when handling the coolant sensor. Damage to the coolant sensor will affect the operation of the fuel control system.


    Object Number: 1554549  Size: SH
  1. Drain the cooling system below the level of the engine coolant temperature (ECT) sensor. Refer to Cooling System Draining and Filling.
  2. Disconnect the ECT sensor electrical connector (1).

  3. Object Number: 50974  Size: SH
  4. Remove the ECT sensor.

Installation Procedure

Caution: Replacement components must be the correct part number for the application. Components requiring the use of the thread locking compound, lubricants, corrosion inhibitors, or sealants are identified in the service procedure. Some replacement components may come with these coatings already applied. Do not use these coatings on components unless specified. These coatings can affect the final torque, which may affect the operation of the component. Use the correct torque specification when installing components in order to avoid damage.

Caution: Use care when handling the coolant sensor. Damage to the coolant sensor will affect the operation of the fuel control system.


    Object Number: 50974  Size: SH
  1. Coat the thread of the ECT sensor with sealer GM P/N 12346004 (Canadian P/N 10953480), or equivalent.
  2. Caution: Refer to Fastener Caution in the Preface section.

  3. Install the ECT sensor.
  4. Tighten
    Tighten the sensor to 20 N·m (15 lb ft).


    Object Number: 1554549  Size: SH
  5. Connect the ECT sensor electrical connector (1).
  6. Refill the engine coolant. Refer to Cooling System Draining and Filling.