GM Service Manual Online
For 1990-2009 cars only

Removal Procedure

Caution: Use care when handling the coolant sensor. Damage to the coolant sensor will affect the operation of the fuel control system.

  1. Partially drain the cooling system. Refer to Cooling System Draining and Filling.
  2. Disconnect the engine coolant temperature (ECT) sensor electrical connector.

  3. Object Number: 186069  Size: SH
  4. Remove the ECT sensor.

Installation Procedure


    Object Number: 186069  Size: SH

    Caution: Use care when handling the coolant sensor. Damage to the coolant sensor will affect the operation of the fuel control system.

    Caution: Replacement components must be the correct part number for the application. Components requiring the use of the thread locking compound, lubricants, corrosion inhibitors, or sealants are identified in the service procedure. Some replacement components may come with these coatings already applied. Do not use these coatings on components unless specified. These coatings can affect the final torque, which may affect the operation of the component. Use the correct torque specification when installing components in order to avoid damage.

  1. Coat the threads with sealer GM P/N 12346004 (Canadian P/N 10953480) or equivalent.
  2. Caution: Refer to Fastener Caution in the Preface section.

  3. Install the ECT sensor.
  4. Tighten
    Tighten the ECT sensor to 25 N·m (18 lb ft).

  5. Connect the ECT sensor electrical connector.
  6. Fill the cooling system. Refer to Cooling System Draining and Filling.