GM Service Manual Online
For 1990-2009 cars only

Removal Procedure

Warning: Relieve the fuel system pressure before servicing fuel system components in order to reduce the risk of fire and personal injury.

After relieving the system pressure, a small amount of fuel may be released when servicing the fuel lines or connections. In order to reduce the chance of personal injury, cover the regulator and the fuel line fittings with a shop towel before disconnecting. This will catch any fuel that may leak out. Place the towel in an approved container when the disconnection is complete.

Warning: Wear safety glasses when using compressed air, as flying dirt particles may cause eye injury.

Warning: Place a dry chemical (Class B) fire extinguisher nearby before performing any on-vehicle service procedures. Failure to follow these precautions may result in personal injury.

Caution: Refer to Cover and Plug Openings Caution in the Preface section.

Note: Always maintain cleanliness when servicing fuel system components.

  1. Relieve the fuel system pressure. Refer to Fuel Pressure Relief.

  2. Object Number: 157703  Size: SH
  3. Grasp both sides of the quick-connect fitting. Twist quick-connect fitting ¼ turn in each direction to loosen any dirt within fitting.

  4. Object Number: 155410  Size: SH
  5. Use compressed air to blow out dirt from the quick-connect fittings at both ends.

  6. Object Number: 12777  Size: SH
  7. Squeeze plastic tabs of male end connector.

  8. Object Number: 12778  Size: SH
  9. Pull the connection apart.
  10. Repeat the step for the other fitting.

  11. Wipe off the male pipe end using a clean shop towel.
  12. Clean or replace the components/assemblies, as required.

Installation Procedure


    Object Number: 155425  Size: SH

    Warning: In order to reduce the risk of fire and personal injury, before connecting fuel pipe fittings, always apply a few drops of clean engine oil to the male pipe ends.

    This will ensure proper reconnection and prevent a possible fuel leak.

    During normal operation, the O-rings located in the female connector will swell and may prevent proper reconnection if not lubricated.

  1. Apply a few drops of clean oil to the male pipe end.

  2. Object Number: 155771  Size: SH
  3. Push both sides of the quick-connect fitting together in order to cause the retaining tabs/fingers to snap into place.

  4. Object Number: 155399  Size: SH
  5. Pull on both sides of the quick connect fitting in order to ensure that the connection is secure.
  6. Tighten the fuel filler cap.
  7. Connect negative battery cable. Refer to Battery Negative Cable Disconnection and Connection.
  8. Inspect for fuel leaks.
  9. 6.1. Turn ON the ignition for 2 seconds.
    6.2. Turn OFF the ignition for 10 seconds.
    6.3. Turn ON the ignition.
    6.4. Inspect for fuel leaks.