SERV. MAN. UPD.-SEC.6D STARTER REMOVAL 3300 ENG.

MODELS AFFECTED: 1989 - 1990 CENTURYS WITH 3300 ENGINES (VIN CODE N)

The procedure in this bulletin replaces the procedure published in the following Service Manuals:

1989 Century Page 6D2-2 1990 Century Page 6D2-1

Starter Motor 3.3L Engine Figure 3

PROCEDURE

REMOVE OR DISCONNECT

1. Negative battery cable.

- Raise the vehicle and suitably support. Refer to General Information (Section OA).

2. Starter motor wiring.

3. Bolts from flywheel cover.

4. Flywheel cover.

5. Bolts from starter motor.

6. Starter motor.

INSTALL OR CONNECT

1. Starter motor.

2. Bolts to starter motor

Tighten - Bolts to 40 N.m (30 lb. ft.)

3. Flywheel cover.

4. Flywheel cover bolts

Tighten - Bolts to 10 N.m (89 lb. in.)

5. Starter motor wiring

- Lower vehicle

6. Negative battery cable

Tighten - Cable.to 12 N.m (106 lb. in.)

General Motors bulletins are intended for use by professional technicians, not a "do-it-yourselfer". They are written to inform those technicians of conditions that may occur on some vehicles, or to provide information that could assist in the proper service of a vehicle. Properly trained technicians have the equipment, tools, safety instructions and know-how to do a job properly and safely. If a condition is described, do not assume that the bulletin applies to your vehicle, or that your vehicle will have that condition. See a General Motors dealer servicing your brand of General Motors vehicle for information on whether your vehicle may benefit from the information.