NO OR SLIPPING IN REVERSE RETURN SPRING/SPIRAL RING

SUBJECT: NO REVERSE OR SLIPPING IN REVERSE (INSTALL NEW RETURN SPRING AND SPIRAL RETAINING RING)

MODELS AFFECTED: 1992-93 SKYLARK AND CENTURY MODELS

CONDITION:

--------- Some 1992-1993 HYDRA-MATIC 3T40 transaxles may slip in reverse, or have no reverse gear.

CAUSE:

----- Internal fluid leaks in the lo and reverse clutch circuit can cause the lo and reverse clutch piston to partially apply when the transaxle is in a drive gear. The current return spring load may not be great enough to keep the piston from partially applying.

CORRECTION:

---------- Replace the lo and reverse clutch return spring, spring retainer and snap ring with a new design clutch belleville return spring and spiral retaining ring. The new clutch return spring has a higher spring rate to keep the piston from partially applying.

SERVICE INFORMATION:

1993 HYDRA-MATIC 3T40 transaxles built beginning July 1, 1992 (Julian Date 182) contain the new design return spring and spiral retaining ring.

The new return spring and spiral retaining ring can be used to service any 1992-1993 HYDRA-MATIC 3T40 transaxle.

NOTICE: Do not install the new design return spring in 1991 or previous HYDRA-MATIC 3T40 transaxles. These models have not had their hydraulic pressures re-calibrated to accept the new spring with a higher spring rate. Transaxle damage will result if this new return spring is installed in 1991 or previous HYDRA-MATIC 3T40 models.

If the previous design return spring and retainer is being replaced with the new design, install the lo blow off line-up from the service package into the transaxle when the return spring is changed.

No change was made to the piston or housing.

The lo and reverse clutch spring retainer (656) was eliminated in the design change.

PARTS INFORMATION:

Parts are currently available from GMSPO.

Part Number Part Name ----------- --------- 8687998 Repair Kit -- Lo/rev Belleville Spring and Retainer (includes new belleville return spring (655), new spiral retaining ring (657), lo blow off spring and plug (325) and lo blow off valve plug (326))

General Motors bulletins are intended for use by professional technicians, not a "do-it-yourselfer". They are written to inform those technicians of conditions that may occur on some vehicles, or to provide information that could assist in the proper service of a vehicle. Properly trained technicians have the equipment, tools, safety instructions and know-how to do a job properly and safely. If a condition is described, do not assume that the bulletin applies to your vehicle, or that your vehicle will have that condition. See a General Motors dealer servicing your brand of General Motors vehicle for information on whether your vehicle may benefit from the information.