Circuit Description
The crankshaft position system variation learning feature is used to
calculate reference period errors caused by slight tolerance variations in
the crankshaft, the crankshaft balancer interrupter rings, and the crankshaft
position sensor hall effect switches. The calculated error allows the PCM
to accurately compensate for reference period varations. This enhances the
ability of the PCM to detect misfire events over a wider range of engine speed
and load.
The crankshaft position system variation values are stored in the PCM
non-volatile memory after a learn procedure has been performed. DTC
P1336 set indicates that the crankshaft position system variation values have
not been stored in the PCM and the crankshaft position system variation learn
procedure must be performed. The learn procedure is required after the following
service procedures have been performed, regardless of whether or not DTC P1336
is set:
| • | Crankshaft replacement. |
| • | Crankshaft balancer replacement. |
| • | Crankshaft position sensor replacement. |
| • | Any engine repair(s) which disturbs crankshaft/harmonic balancer
to crankshaft position sensor relationship. |
Conditions for Running the DTC
| • | No CMP or CKP sensor DTC(s) set. |
| • | Engine Coolant Temperature is greater than 70°C (158°F). |
Conditions for Setting the DTC
Crankshaft position system variation values are not stored in the PCM
memory.
Action Taken When the DTC Sets
| • | The PCM will illuminate the MIL during the first trip in which
the diagnostic test has been run and failed. |
| • | The PCM will store conditions which were present when the DTC
set as Freeze Frame and Fail Records data. |
Conditions for Clearing the MIL/DTC
| • | The PCM will turn the MIL OFF during the third consecutive trip
in which the diagnostic has been run and passed. |
| • | The history DTC will clear after 40 consecutive warm-up cycles
have occurred without a malfunction. |
| • | The DTC can be cleared by using the scan tool Clear Info function
or by disconnecting the PCM battery feed. |
Diagnostic Aids
The crankshaft position system variation compensating values are stored
in the PCM non-volatile memory after a learn procedure has been performed.
If the actual crankshaft position variation is no within the crankshaft position
system variation compensating values stored in the PCM, DTC P0300 may set
(refer to Diagnostic Aids for DTC P0300).
The crankshaft position system variation learn procedure must be performed
when replacing the PCM to clear DTC P1336. The crankshaft position system
variation learn procedure is also required when the following service procedures
have been performed, regardless of whether or not DTC P1336 is set:
| • | Crankshaft replacement. |
| • | Crankshaft balancer replacement. |
| • | Crankshaft position sensor replacement. |
| • | Any engine repair(s) which disturbs crankshaft/harmonic balancer
to crankshaft position sensor relationship. |
If the crankshaft position system variation learn procedure cannot be
performed sucessfully, check for the following conditions and correct as necessary:
| • | Engine coolant temperature below 70°C (158°F). |
| | Allow the engine to warm to above 70°C (158°F). |
| | The scan tool crankshaft position system variation learn function will
be disabled if any powertrain DTCs other than DTC P1336 are stored. |
| • | Camshaft position signal problem detected. |
| • | 3X reference signal problem detected. |
| • | 18X reference signal problem detected. |
