Step
| Action
| Normal Result(s)
| Abnormal Result(s)*
|
1
|
- Inspect the following areas for battery acid:
• | The area around and underneath the battery tray |
- Inspect the battery for a cracked, broken, or damaged case.
|
• | The battery case, the battery tray, and the surrounding area are
dry. |
• | The battery is not cracked, broken, or damaged. |
| The battery
case, the battery tray, and the surrounding area are wet. The battery is cracked,
broken, or damaged.
Battery Tray Replacement
.
|
2
| Compare
the Cold Cranking Amperage (CCA) and the Reserve Capacity (RC) of the battery
or the Original Equipment (OE) specification. Go to
Battery Usage
.
| The ratings of the vehicle battery meet or exceed the CCA
and the RC of the original equipment specification.
| The ratings of the vehicle battery do not
meet the CCA and the RC of the original equipment specification,
Battery Tray Replacement
.
|
3
| Inspect the battery hydrometer for a green
dot.
| The battery
hydrometer displays a green dot.
|
|
4
| Turn
the ignition key to START and check to see if the engine cranks normally and
starts.
| The engine cranks normally and starts.
|
|
5
|
- Inspect the battery for proper installation and retention in the
battery tray.
- Inspect the battery terminals for clean and tight connections.
|
• | The battery is firmly held in place in the tray and the hold-down
bolt is properly tightened. |
• | The battery terminals are clean and tight. |
|
|
* Refer to the appropriate symptom diagnostic table for
the applicable abnormal result.
|