Step
| Action
| Value(s)
| Yes
| No
|
1
| Did you perform the BCM diagnostic system check?
| --
| Go to
Step 2
| Go to
Diagnostic System Check - Body Control System
|
2
| Did you perform the Remote
Keyless Entry diagnostic system check?
| --
| Go to
Step 3
| Go to
Remote Keyless Entry System Check
|
3
|
- Turn the headlamp switch to the HEAD position.
- Observe the headlamps.
Are the headlamps on?
| --
| Go to
Step 4
| Go to
Exterior Lights System Check
|
4
|
- Turn off the headlamps.
- Momentarily, press the horn switch.
Does the horn sound?
| --
| Go to
Step 5
| Go to
Horns System Check
|
5
|
- Remove the key from the ignition key lock cylinder.
- Close all of the vehicle doors.
- Press the LOCK button and, then, the UNLOCK button on the driver's
door lock switch, while observing the door locks.
- Press the LOCK and, then, the UNLOCK button on the passenger door
lock switch, while observing the door locks.
Do all of the doors lock and unlock when using either door lock switch?
| --
| Go to
Step 6
| Go to
Power Door Locks System Check
|
6
|
- Replace the RCDLR.
- Connect the BCM.
- Reprogram all of the transmitters. Refer to
Transmitter Programming
- Ensure that the key has been removed from the ignition key cylinder
lock.
- Close all of the vehicle doors.
- Press the LOCK button on the keyless entry transmitter 1 time,
while observing the door locks.
- Press the UNLOCK button on the keyless entry transmitter 2 time,
while observing the door locks.
- Press the alarm button on the keyless entry transmitter, while
observing the headlamps and listening to the horn.
Does the keyless entry system operate the door locks and alarm?
| --
| Go to
Remote Keyless Entry System Check
| Go to
Step 7
|
7
|
- Replace the BCM. Refer to
Body Control Module Replacement
in Body Control System.
- After BCM replacement, perform the Setup New BCM Procedure. Refer
to
Body Control Module (BCM) Programming/RPO Configuration
in Body Control System.
Is the repair complete?
| --
| Go to
Step 8
| --
|
8
|
- Turn the ignition switch to the LOCK position.
- Install any connectors or components that were removed.
Is the action complete?
| --
| Go to
Remote Keyless Entry System Check
| --
|
