Tools Required

J 25070 Heat Gun

Important: Be careful not to damage the paint.

1. Heat to remove the body side emblem using the J 25070 152 mm (6 inches) from surface.
2. Apply heat using a circular motion for about 30 seconds.
3. Remove the body side emblem using a plastic flat-bladed tool.
4. Remove all adhesive from body panel(s) using 3M Scotch Brite molding adhesive remover disk 3M P/N 07501 or equivalent.
5. Clean the body panel using Varnish Makers and Painters (VMP) naphtha.

Important: Apply emblems in an environment that is free from dust or other dirt that could come in contact with the sticky backing. This may cause improper adhesion.

1. Clean the area where the emblems will be mounted.
2. Heat the area using the J 25070 to a temperature of 27°-41° C (80°-105° F).
3. Ensure that the temperature of the emblems is within 29°-32° C (85°-90° F). Place the emblems, with the adhesive side down, on a surface and use a heat gun to warm up.
4. Remove the protective liner from the back of the emblem.



5. Apply the body side emblem to the body surface.
6. Apply equal pressure along the emblems in order to uniformly bond the items to the body surface.