Tools Required

J 37096 Flywheel Holder

1. Remove the automatic transaxle. Refer to Transmission Replacement in Automatic Transaxle - 4T65-E.
2. Use the J 37096 to secure the flywheel in order to prevent rotation.



3. Loosen the 6 flywheel bolts.
4. Remove 5 of the 6 flywheel bolts leaving 1 bolt at the top of the crankshaft rotation.
5. Grip the flywheel and remove the remaining bolt. Do not drop the flywheel when removing the final bolt.
6. Remove the engine flywheel and the flywheel retainer.
7. Clean the engine flywheel bolt threads and bolt holes.

1. Install the flywheel and the retainer.

Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.

2. Install the engine flywheel bolts. Use the J 37096 to prevent flywheel rotation.

Tighten
Tighten the bolts to 71 N·m (52 lb ft).

3. Install the automatic transaxle. Refer to Transmission Replacement in Automatic Transaxle - 4T65-E.