Removal Procedure
- Raise and support the vehicle. Refer to
Lifting and Jacking the Vehicle
in General Information.
- Position the oil drain pan under the engine oil drain plug.
- Remove the engine oil drain plug.
- Clean and inspect the engine oil drain plug, repair or replace if necessary.
- Clean and inspect the engine oil drain plug sealing surface on the oil
pan, repair or replace oil pan if necessary.
- Remove the oil filter.
- Clean and inspect the oil filter sealing area on the engine block, repair
or replace if necessary.
Installation Procedure
- Lightly oil the replacement oil filter gasket with clean oil and install
the new oil filter.
Notice: Refer to Fastener Notice in the Preface section.
- Install the new oil filter.
Tighten
Tighten the new oil filter to 3/4 to 1 full turn, after the oil filter gasket
contacts the oil filter mounting surface.
- Install the engine oil pan drain plug.
Tighten
Tighten the plug to 30 N·m (22 lb ft).
- Remove the oil drain pan.
- Lower the vehicle.
- Fill the engine with new engine oil.
- Start the engine.
- Inspect for oil leaks after engine start up.
- Turn off the engine and allow the oil a few minutes to drain back into
the oil pan.
- Remove the oil level indicator from the oil level indicator tube.
- Clean off the indicator end of the oil level indicator with a clean paper
towel or cloth.
- Install the oil level indicator into the oil level indicator tube until
the oil level indicator handle contacts the top of the oil level indicator tube.
- Again, remove the oil level indicator from the oil level indicator tube
keeping the tip of the oil level indicator down.
- Check the level of the engine oil on the oil level indicator.
- If necessary, adjust the oil level by adding or draining the engine oil.