Removal Procedure
- Remove the left instrument panel insulator. Refer to
Instrument Panel Trim Pad Replacement
in Instrument Panel, Gages and Console.
- Remove the instrument panel knee bolster bracket. Refer to
Knee Bolster Replacement
in Instrument Panel, Gages and Console.
- Disconnect the vacuum line from the mode actuator.
- Lift the lock tab up (1) to remove the actuator.
- Remove the mode actuator off the slides of the HVAC module assembly.
- Disconnect the actuator pushrod from the mode door lever and remove the actuator.
Installation Procedure
- Connect the actuator pushrod to the mode door lever.
- Position the actuator on to the slides of the HVAC module assembly.
- Ensure that the lock tab (1) locks the actuator.
- Connect the vacuum lines to the mode actuator.
- Install the instrument panel knee bolster bracket. Refer to
Knee Bolster Replacement
in Instrument Panel, Gages and Console.
- Install the left instrument panel insulator. Refer to
Instrument Panel Trim Pad Replacement
in Instrument Panel, Gages and Console.