Removal Procedure
- Apply the park brake.
- Remove the steering column filler panel. Refer to
Steering Column Opening Filler Replacement
.
- Remove the accessory trim plate, if not equipped with a front
floor console. Refer to
Instrument Panel Accessory Trim Plate Replacement
.
- Adjust the front floor console for access, if equipped. Refer
to
Front Floor Console Replacement
.
- If equipped with column shift, adjust the shift lever to LOW.
- Remove the instrument
panel (I/P) outer trim covers.
- Open the I/P compartment.
- Remove the filler panel from the lower section of the I/P. Refer
to
Instrument Panel Outer Trim Cover Replacement
.
- Remove the screw from
the right end of the I/P cluster trim plate.
- Release the retaining
tab on the right end of the trim plate.
- Tilt the steering column to the lowest position.
- Pull the trim plate at the right edge, working towards the left
slowly, in order to release the retaining clips.
- Remove the I/P trim plate.
Installation Procedure
- Position the trim plate to the I/P.
- Install the trim plate by pressing in at each retainer location
until seated correctly.
- Return the steering column to the original position.
Notice: Use the correct fastener in the correct location. Replacement fasteners
must be the correct part number for that application. Fasteners requiring
replacement or fasteners requiring the use of thread locking compound or sealant
are identified in the service procedure. Do not use paints, lubricants, or
corrosion inhibitors on fasteners or fastener joint surfaces unless specified.
These coatings affect fastener torque and joint clamping force and may damage
the fastener. Use the correct tightening sequence and specifications when
installing fasteners in order to avoid damage to parts and systems.
- Install the screw to right end of the trim plate.
Tighten
Tighten the screw to 2 N·m (18 lb in).
- Install the filler panel to the lower section of the I/P. Refer
to
Instrument Panel Outer Trim Cover Replacement
.
- Close the I/P compartment.
- Install the outer trim
covers by pressing each cover into place until seated correctly.
- If equipped with column shift, adjust the shift lever to PARK.
- Install the front floor console, if equipped. Refer to
Front Floor Console Replacement
.
- Install the accessory trim plate, if not equipped with a front
floor console. Refer to
Instrument Panel Accessory Trim Plate Replacement
.
- Install the steering column filler panel. Refer to
Steering Column Opening Filler Replacement
.
- Release the park brake.