Circuit Description
The body control module (BCM) produces the theft deterrent crank relay and fuel enable signal when ignition is ON and the proper ignition code voltage value is detected. The powertrain control module (PCM) monitors the fuel enable signal during crank. If the proper signal is present on the Class 2 Serial Data Circuit, the PCM enables the fuel delivery in order to allow the engine to start. If the PCM determines that the fuel enable signal is not present or incorrect during engine crank, DTC P1629 is set. The engine will not start as long as DTC P1629 is stored.
Conditions for Running the DTC
| • | DTC P1626 is not present. |
| • | An attempt is made to start the engine. |
Conditions for Setting the DTC
The PCM has detected a loss of the state of health serial data message from the theft deterrent system during engine crank.
Action Taken When the DTC Sets
| • | The powertrain control module (PCM) will not illuminate the malfunction indicator lamp (MIL). |
| • | The PCM will store conditions which were present when the DTC set as failure records data only. This information will not be stored as freeze frame data. |
Conditions for Clearing the DTC
| • | A history DTC will clear after 40 consecutive warm-up cycles have occured without a malfunction. |
| • | The DTC can be cleared by using a scan tool. |
Step | Action | Yes | No |
|---|---|---|---|
Schematic Reference: Theft Deterrent System Schematics | |||
1 | Did you perform the Theft Deterrent Diagnostic System Check? | Go to Step 2 | |
2 |
Important: DTC P1629 can only be set along with a corresponding theft deterrent B-code. Refer to the DTC list in order to diagnose the appropriate theft deterrent B-code. Is DTC P1629 set as a current DTC? | Go to Testing for Intermittent Conditions and Poor Connections in Wiring Systems | |
