For 1990-2009 cars only
Removal Procedure
- Carefully push the outside rearview mirror face on the inner edge (near the front door window glass) to allow finger access.
- Grasp the mirror face firmly and pull it from the mirror body.
- Remove the outside rearview mirror case from the outside rearview mirror housing and disconnect the heater wire (if equipped).
- Remove the 2 jackscrews from back of the mirror case.
Caution: Approved safety glasses and gloves should be worn when performing this procedure to reduce the chance of personal injury.
Important: The outside mirrors are stud mounted to the door metal. The mirror face can be replaced without removing the entire mirror. The left side flat and right side convex mirror faces must be replaced with the same type mirror face when serviced.
| 4.1. | Bend the 2 jackscrews over. |
| 4.2. | Press down on the side of the jackscrew popping the screw from the mirror glass case. |
| 4.3. | Save the jackscrews for reinstallation to the mirror motor. |
Installation Procedure
- Push the jackscrews into the mirror motor.
- Rotate both jackscrews to position the ball flanges to be inline with the attaching hub. They will then be correctly positioned to the mirror face.
- Install the electric heater wire to the mirror, if equipped.
- Align the wire stabilizers (if equipped) on the mirror case to the motor. Also align the mirror case to the motor.
- With the palm of your gloved hand, press firmly on the center of the glass until the case seats onto the motor.
- With the palm of you gloved hand pivot the mirror face to engage the jackscrews.
- Check the mirror operation and clean the glass face.
Important: The jackscrew springs must be positioned on the fingers (opposite the ball end) to compress the fingers.
The jackscrews will give a clicking noise when properly seated.
