For 1990-2009 cars only
Removal Procedure
- Open and support the hood.
- Lift the retainer clips on the assist rod using a small flat-bladed tool.
- Pull the upper end of the assist rod from the ball joint on the hood.
- Pull the lower end of the assist rod from the ball joint on the lower hood hinge.
Caution: When a hood hold open device is being removed or installed, provide alternate support to avoid the possibility of damage to the vehicle or personal injury.
Notice: Apply pressure only at the end of the liftgate/hood assist rod that you are removing or attaching. Do NOT apply pressure to the middle of the rod because damage or bending will result.
Installation Procedure
- Press the upper end of the assist rods onto the ball joint on the hood.
- Press the lower end of the assist rods onto the ball joint on the lower hood hinge
- Remove the support from the hood.
- Close the hood.
Notice: Apply pressure only at the end of the liftgate/hood assist rod that you are removing or attaching. Do NOT apply pressure to the middle of the rod because damage or bending will result.
