GM Service Manual Online
For 1990-2009 cars only
Makes 🢒 Buick 🢒 2005 🢒 Century 🢒 Body 🢒 Wiring Systems 🢒 Instrument Panel Inflatable Restraint Module Replacement

Removal Procedure

    Caution: Refer to SIR Caution in the Preface section.

    Caution: Refer to SIR Inflator Module Handling and Storage Caution in the Preface section.


    Object Number: 238077 Size: SH
  1. Disable the SIR system. Refer to SIR Disabling and Enabling .
  2. Remove the instrument panel (I/P) trim pad. Refer to Instrument Panel Trim Pad Replacement in Instrument Panel, Gages and Console.
  3. Remove the mounting fasteners (3) from the inflatable restraint I/P module.
  4. Remove the I/P module (2) from the cross-car beam (1).
  5. Fully deploy the module before disposal. If the module was replaced under warranty, fully deploy and dispose of the module after the required retention period. Refer to Inflator Module Handling and Scrapping .

Installation Procedure

    Object Number: 238077 Size: SH
  1. Install the I/P module (2) to the cross-car beam (1).

    2. Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.

  2. Install the I/P module mounting fasteners (3).

    3. Tighten
    Tighten the fasteners to 10 N·m (89 lb in).

  3. Install the I/P trim pad. Refer to Instrument Panel Trim Pad Replacement in Instrument Panel, Gages and Console.
  4. Enable the SIR system. Refer to SIR Disabling and Enabling .