The ignition control (IC) module sends signals that the Powertrain Control Module (PCM) requires for fuel control and spark advance calculations. At the start of engine crank, the IC module controls spark advance (bypass mode). When the second 3X reference pulse is recognized by the PCM, the PCM applies 5 volts to the bypass circuit, commanding the IC module to switch spark advance to PCM control (IC mode). If the PCM detects an open in the bypass circuit, DTC P1352 will set. The engine will start and may run in bypass mode timing.
The engine is running.
The PCM detects an open circuit in the bypass circuit.
• | The PCM will illuminate the malfunction indicator lamp (MIL) during the second consecutive trip in which the diagnostic test has been run and failed. |
• | The PCM will store conditions which were present when the DTC set as Freeze Frame/Failure Records data. |
• | The PCM will turn OFF the malfunction indicator lamp (MIL) during the third consecutive trip in which the diagnostic has run and passed. |
• | The history DTC will clear after 40 consecutive warm-up cycles have occurred without a malfunction. |
• | The DTC can be cleared by using a scan tool. |
Inspect for the following conditions:
• | Poor connection at the PCM-- Inspect harness connectors for: |
- | Backed out terminals |
- | Improper mating |
- | Broken locks |
- | Improperly formed or damaged terminals |
- | Poor terminal to wire connection |
• | Damaged harness-- Inspect the wiring harness for damage. If the harness appears to be OK, disconnect the IC module, turn the ignition on and observe a DMM connected between the IC circuit and battery positive voltage while moving connectors and wiring harnesses related to the IC module. A change in voltage will indicate the location of the malfunction. |
Reviewing the Failure Records vehicle mileage since the diagnostic test last failed may help determine how often the condition that caused the DTC to be set occurs. This may assist in diagnosing the condition.
Step | Action | Values | Yes | No |
---|---|---|---|---|
1 | Did you perform the Powertrain On-Board Diagnostic (OBD) System Check? | -- | ||
2 |
Does the DMM display a resistance above the specified value? | 5,000 ohms | ||
3 |
Was a problem found? | -- | ||
4 |
Was a problem found? | -- | ||
5 |
Was a problem found? | -- | ||
6 | Replace the IC module. Refer to Ignition Control Module Replacement . Is the action complete? | -- | -- | |
7 |
Important: : The replacement PCM must be programmed. Replace the PCM. Refer to Powertrain Control Module Replacement/Programming . Is the action complete? | -- | -- | |
8 |
Does the scan tool indicate DTC 1352 failed this ignition? | -- | System OK |