Removal Procedure
- Remove the left instrument panel (IP) insulator. Refer to
Instrument Panel Insulator Replacement
.
- Remove the bolt from the
bottom of the steering column opening panel.
- Pull the steering column opening panel rearward and upward, releasing
retaining clips from the IP.
- Disconnect the electrical connector from the IP accessory switch
assembly, if equipped.
- Remove the steering column opening panel.
Installation Procedure
- Connect the electrical connector to the IP accessory switch assembly,
if equipped.
- Align the steering column
opening panel locating pins and the retainers clip to the slots in the IP.
- Press the steering column opening panel to lock in the retainers.
Notice: Use the correct fastener in the correct location. Replacement fasteners
must be the correct part number for that application. Fasteners requiring
replacement or fasteners requiring the use of thread locking compound or sealant
are identified in the service procedure. Do not use paints, lubricants, or
corrosion inhibitors on fasteners or fastener joint surfaces unless specified.
These coatings affect fastener torque and joint clamping force and may damage
the fastener. Use the correct tightening sequence and specifications when
installing fasteners in order to avoid damage to parts and systems.
- Install the bolt
to the bottom of the steering column opening panel.
Tighten
Tighten the steering column opening panel bolt to 2 N·m
(18 lb in).
- Install the left instrument panel insulator. Refer to
Instrument Panel Insulator Replacement
.