For 1990-2009 cars only
Removal Procedure
- Remove the left instrument panel insulator. Refer to Instrument Panel Insulator Replacement in Instrument Panel Gauges and Console.
- Unclip the BCM and position aside.
- Remove the stoplamp switch. Refer to Stop Lamp Switch Replacement .
- Remove the wiring harness clips.
- Remove the brake pedal pushrod retaining clip at the brake pedal.
- Remove the brake pedal pushrod and washer.
- Inspect all parts for evidence of wear. Repair or replace the worn parts as needed.
- Remove the brake pedal nut and bolt.
- Remove the brake pedal and bushings.
Installation Procedure
- Install the brake pedal and bushings.
- Install the brake pedal nut and bolt.
- Install the brake pedal washer and pushrod.
- Install the brake pedal pushrod retaining clip.
- Install the wiring harness clips.
- Install the stoplamp switch. Refer to Stop Lamp Switch Replacement .
- Position and clip the BCM into place.
- Install the left instrument panel insulator. Refer to Instrument Panel Insulator Replacement in Instrument Panel Gauges and Console.
Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.
Tighten
Tighten the brake pedal nut and bolt to 40 N·m(30 lb ft).
