For 1990-2009 cars only
- Install the ignition and key alarm switch assembly (1) onto the lock module assembly.
- Screw the 2 tapping screws (2) into the ignition and key alarm switch assembly (1).
- Install the key alarm connector (1) into the lock module assembly (2).
- Slide the 2 (2) connectors of the turn signal and multifunction switch assembly into the bulkhead connector (1).
- Attach the wire harness strap (2) to the wire harness assembly (1) and the steering column.
- Install the upper and lower trim covers. Refer to Steering Column Trim Covers - Assemble - Off Vehicle .
Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.
Tighten
Tighten the 2 tapping screws to 1.5 N·m (13 lb in).
| 3.1. | Push the key alarm connector (1) into the lock module assembly (2). |
| 3.2. | Rotate the key alarm connector (1) 90 degrees so that the key alarm connector (1) locks into place. |
