Removal Procedure
- Remove the left side instrument
panel insulator. Refer to
Instrument Panel Insulator Replacement
in Instrument Panel, Gauges and Console.
- Remove the left carpet retainer and pull carpet back. Refer to
Carpet Retainer Replacement
in Interior Trim
- Disconnect the electrical connector from the switch.
- Remove the mounting screw.
- Remove the parking brake indicator switch (1).
Installation Procedure
- Install the parking brake
indicator switch (1).
Notice: Use the correct fastener in the correct location. Replacement fasteners
must be the correct part number for that application. Fasteners requiring
replacement or fasteners requiring the use of thread locking compound or sealant
are identified in the service procedure. Do not use paints, lubricants, or
corrosion inhibitors on fasteners or fastener joint surfaces unless specified.
These coatings affect fastener torque and joint clamping force and may damage
the fastener. Use the correct tightening sequence and specifications when
installing fasteners in order to avoid damage to parts and systems.
- Install the mounting
screw.
Tighten
Tighten the mounting screw to 3 N·m (26 lb in).
- Connect the electrical connector to the switch.
Check the operation of the switch.
- Install the left carpet retainer and carpet. Refer to
Carpet Retainer Replacement
in Interior
Trim.
- Install the left side instrument panel insulator. Refer to
Instrument Panel Insulator Replacement
in Instrument Panel, Gauges and Console.