Step
| Action
| Value(s)
| Yes
| No
|
|
Important: The vehicle is equipped with supplemental inflatable restraints (SIR).
Do not confuse the 2-way steering column lock and ignition key cylinder connector
(C207) with the yellow 2-way SIR connector.
|
1
| Using a scan tool, inspect for BCM DTCs.
Are there any BCM DTCs present?
| --
| Go to
Vehicle Theft Deterrent (VTD) System Check
| Go to
Step 2
|
2
|
- Insert the ignition key into the J 35628-A
.
- Turn on the J 35628-A
.
- Read the key code that is on the display of the interrogator.
Does the J 35628-A
display a key code value of 1 through 15?
| --
| Go to
Step 3
| Go to
Step
6
|
3
|
- Write down the key code that is displayed on the J 35628-A
.
- Turn off the J 35628-A
.
- Connect the J 35628-A
.
- Insert the ignition key into the ignition key lock cylinder.
- Turn on the J 35628-A
.
- Turn the ignition switch to RUN and observe the display on the J 35628-A
.
Does the J 35628-A
display a key code that matches the key code in step 2?
| --
| Go to
Step 4
| Go to
Step 7
|
4
| Were you referred to this table by a DTC table?
| --
| Go to the appropriate
DTC table
| Go to
Step 5
|
5
|
- Verify that the ignition switch is in the LOCK position.
- Connect all of the connectors.
- Install any components that were removed.
- Connect a scan tool to the data link connector (DLC).
- Turn the ignition switch to the RUN position.
- Use the scan tool in order to clear the BCM DTCs. Refer to
Clearing DTCs
in Body Control System.
- Turn the ignition switch to the LOCK position.
- Turn the ignition switch to the RUN position.
- Use a scan tool in order to test for current BCM DTCs. Refer to
Diagnostic Trouble Code (DTC) Displaying
in Body Control System.
Are there any current BCM DTCs?
| --
| Go to the appropriate DTC table
| Go to
|
6
|
- Clean the ignition key.
- Use the J 35628-A
.
- If the key code is still invalid, replace the key. Refer to
Programming Replacement Keys, Ignition Cylinder, or Powertrain Control Module
.
Is the repair complete?
| --
| Go to
Step
3
| --
|
7
|
- Test for a poor connection at the ignition key lock cylinder.
- If the connection is good, replace the ignition key lock cylinder.
Refer to
Steering Column Lock Cylinder Set - Disassemble - Off Vehicle
and
Steering Column Lock Cylinder Set - Assemble - Off Vehicle
in Steering
Wheel and Column - Tilt.
Is the repair complete?
| --
| Go to
Step
4
| --
|
