Caution:  When a hood hold open device is being removed or installed, provide alternate support to avoid the possibility of damage to the vehicle or personal injury.

1. Open and support the hood.
2. Lift up the retainer clips on the hood strut support using a small flat-bladed tool.

Notice: Apply pressure only at the end of the liftgate/hood assist rod that you are removing or attaching. Do NOT apply pressure to the middle of the rod because damage or bending will result.




3. Pull the upper end of hood strut support from the ball joint on hood.
4. Pull the lower end of the hood strut support from the ball joint on the lower hood hinge.

Important: Pressure to remove or attach the hood strut supports ends must be placed at end of the hood strut that is being removed or attached. Do not apply pressure to the mid section of the hood strut when removing or installing as this will bend and damage the hood strut.




1. Press the upper end of hood strut support to the ball joint on hood.
2. Press the lower end of the hood strut support to ball joint on the lower hood hinge
3. Remove the support from the hood.
4. Close the hood.