Step | Action | Value(s) | Yes | No |
|---|---|---|---|---|
1 | Was the Wiper/Washer System Check performed? | -- | Go to Step 2 | |
2 |
Is the measurement greater than the specified value? | 1.0 V | Go to Step 6 | Go to Step 3 |
3 | Check for a poor connection at connector C201, or for an open in the pigtail to the wiper/washer switch. Is a poor connection or an open present? | -- | Go to Step 5 | Go to Step 4 |
4 | Replace the wiper/washer switch. Refer to Multifunction Turn Signal Lever Replacement - On Vehicle . Is the replacement complete? | -- | -- | |
5 | Repair the poor connection at connector C201 or the open in the pigtail to the wiper/washer switch. Is the repair complete? | -- | -- | |
6 |
Is the measurement greater than the specified value? | 1.0 V | Go to Step 8 | Go to Step 7 |
7 | Repair the open in CKT 113. Is the repair complete? | -- | -- | |
8 | Backprobe from the wiper/washer switch connector C201, terminal E2, to ground with a DMM. Is the measurement greater than the specified value? | 1.0 V | Go to Step 11 | Go to Step 9 |
9 | Check for a poor connection at connector C201, or for an open in the pigtail to the wiper/washer switch. Is a poor connection or an open present? | -- | Go to Step 5 | Go to Step 10 |
10 | Replace the wiper/washer switch. Refer to Multifunction Turn Signal Lever Replacement - On Vehicle . Is the replacement complete? | -- | -- | |
11 | Measure the voltage from the wiper motor connector, terminal E, to ground with a DMM. Is the measurement greater than the specified value? | 1.0 V | Go to Step 13 | Go to Step 12 |
12 | Repair the open in CKT 112. Is the repair complete? | -- | -- | |
13 | Replace the wiper motor cover. Refer to Wiper Motor Cover Replacement . Is the replacement complete? | -- | -- |
