Circuit Description
The Instrument Panel Cluster (IPC) turns the ABS Indicator on during the IPC bulb check for approximately 3 seconds, then OFF, when the ignition switch is turned to the RUN position. If the EBCM/EBTCM sets a Diagnostic Trouble Code (DTC) the EBCM/EBTCM sends a class 2 message to the IPC to command the ABS Indicator on.
Diagnostic Aids
| • | It is very important that a thorough inspection of the wiring and connectors be performed. Failure to carefully and fully inspect wiring and connectors may result in misdiagnosis, causing part replacement with reappearance of the malfunction. |
| • | Thoroughly inspect any circuitry that may be causing the complaint for the following conditions: |
| - | Backed out terminals |
| - | Improper mating |
| - | Broken locks |
| - | Improperly formed or damaged terminals |
| - | Poor terminal-to-wiring connections |
| - | Physical damage to the wiring harness |
| • | The following conditions may cause an intermittent malfunction: |
| - | A poor connection |
| - | Rubbed-through wire insulation |
| - | A broken wire inside the insulation |
| • | If an intermittent malfunction exists refer to Intermittents and Poor Connections Diagnosis in Wiring Systems. |
Step | Action | Value(s) | Yes | No |
|---|---|---|---|---|
DEFINITION: ABS Indicator does not turn come ON during the Instrument Panel Cluster (IPC) bulb check and no ABS/TCS DTC(s) set. | ||||
1 | Was the Diagnostic System Check performed? | -- | ||
2 |
Will the scan tool command the ABS Indicator ON then OFF? | -- | ||
3 | Replace the EBCM/EBTCM. Refer to Electronic Brake Control Module/Electronic Brake and Track Control Module Replacement . Is the replacement complete? | -- | -- | |
4 | Suspect the Instrument Panel. Refer to Diagnostic System Check - Instrument Cluster in Instrument Panel, Gauges and Console. Is the repair complete? | -- | -- | |
