1. Loosen the two 13 mm door side hinge bolts. Do not remove the bolts.
2. Adjust the door up or down and in or out by repositioning the door as necessary.

Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.

Tighten the two 13 mm door side hinge bolts.

Tighten
Tighten the door side hinge bolts (13 mm Hex Head) to 33 N·m (24 lb ft).

1. Remove the front fender insulator to gain access to the body side hinge bolts. Refer to Front Fender Insulator Replacement in Body Front End.



2. Loosen the two 13 mm body side hinge bolts (1). Do not remove the bolts.



3. Loosen the one 10 mm cone adjuster body side hinge bolt (1). Do not remove the bolt.
4. Loosen one torx body side hinge bolt. Do not remove the bolt.
5. Adjust the door fore and the aft by repositioning the door as necessary.

Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.

1. Tighten one torx body side hinge bolt.

Tighten
Tighten the torx head body side hinge bolt to 10 N·m (89 lb in).




2. Tighten one 10 mm cone adjuster body side hinge bolt (3).

Tighten
Tighten the cone adjuster body side hinge bolt to 10 N·m (89 lb in).

3. Install the two 13 mm body side hinge bolts (1).

Tighten
Tighten the body side hinge bolts to 33 N·m (24 lb ft).

4. Install the front fender insulator. Refer to Front Fender Insulator Replacement in Body Front End.