Step
| Action
| Value(s)
| Yes
| No
|
1
| Was the Rear Compartment Lid Release System Check performed?
| --
|
Go to Step
2
| Go to
Rear Compartment Lid Release System Check
|
2
| Install
scan tool and check for Diagnostic Trouble Code (DTC) in the Body Control
Module (BCM).
Is DTC B3268 set?
| --
|
Go to Step 3
| Go to
DTC B3268 Decklid Output Relay Short to BATT
in Body Control Systems
|
3
|
- Disconnect the rear compartment lid latch release actuator connector.
- Manual close the trunk lid
Will the trunk lid latch?
| --
|
Go to Step 4
|
Go to Step 5
|
4
|
- Disconnect the rear compartment lid release relay.
- With a test light, backprobe between the relay terminal A2
and ground.
Does the test light illuminate?
| --
|
Go to Step 6
|
Go to Step 7
|
5
|
- Check the mechanical operation of the rear compartment.
- Look for bindings, lid gap adjustments and latch operation, etc.
- If lid mechanical condition is OK, replace rear compartment lid
lock release actuator. Refer to
Release Actuator Replacement
for service procedure.
Is the repair complete?
| --
|
Go to Step 8
| --
|
6
| Repair a short to B+ in circuit 56.
Is the repair complete?
| --
|
Go to Step 8
| --
|
7
| Replace the rear compartment lid release relay.
Is the repair complete?
| --
|
Go to Step 8
| --
|
8
|
- Turn the ignition switch to the LOCK position.
- Reconnect all the connectors/components that have been disconnected.
Are all repairs complete?
| --
| Go to
Rear Compartment Lid Release System Check
| --
|
