Windshield Washer Solvent Heater Replacement. Buick Enclave 2008

For 1990-2009 cars only

Makes 🢒 Buick 🢒 2008 🢒 Enclave 🢒 Engine 🢒 Engine Controls and Fuel - 2.8L, 3.0L, 3.2L, or 3.6L 🢒 Windshield Washer Solvent Heater Replacement

Windshield Washer Solvent Heater Replacement Acadia, Enclave, OUTLOOK

Callout	Component Name
Preliminary Procedure Remove the air cleaner outlet duct. Refer to Air Cleaner Outlet Duct Replacement.
1	Windshield Washer Hose (Outlet) Tip Disconnect the air inlet panel jumper hose from the outlet side of the heater assembly.
2	Windshield Washer Pump Hose (Inlet)
3	Windshield Washer Solvent Heater Nuts (Qty: 2) Notice: Refer to Fastener Notice in the Preface section. Tighten Tighten the nuts to 10 N·m (89 lb in).
4	Windshield Washer Solvent Heater Assembly Procedure Disconnect the electrical connectors after removing the heater from the lower plenum panel studs. Prime the heated washer fluid unit after installation. Cycle the normal wash function until washer fluid sprays from the windshield washer nozzles. The normal wash function fills the heated washer unit with washer solvent after replacement. Activate the heated washer spray function and inspect for proper operation.