GM Service Manual Online
For 1990-2009 cars only
Makes 🢒 Buick 🢒 2008 🢒 Enclave 🢒 Diagnostic Navigation 🢒 Vehicle Diagnostic Information 🢒 Camshaft Position Sensor Replacement - Bank 2 (Left Side) Intake

Removal Procedure

    Object Number: 1856014 Size: SH
  1. Remove the engine mount strut bracket. Refer to Engine Mount Strut Bracket Replacement - Right Side .
  2. Remove the radiator inlet hose from the water outlet. Refer to Radiator Inlet Hose Replacement .
  3. Remove the power steering fluid reservoir bracket bolts (1).
  4. Remove and reposition the power steering fluid reservoir bracket (2) out of the way.

    5. Object Number: 1860429 Size: SH
  5. Disconnect the engine wiring harness electrical connector (8) from the bank 2 intake camshaft position (CMP) sensor (7).

    6. Object Number: 1860459 Size: SH
  6. Remove the CMP sensor bolt and sensor (3).

Installation Procedure

    Notice: Refer to Fastener Notice in the Preface section.


    Object Number: 1860459 Size: SH
  1. Install the CMP sensor (3) and bolt.

    2. Tighten
    Tighten the bolt to 10 N·m (89 lb in).


    Object Number: 1860429 Size: SH
  2. Connect the engine wiring harness electrical connector (8) to the bank 2 intake CMP sensor (7).

    3. Object Number: 1856014 Size: SH
  3. Position and install the power steering fluid reservoir bracket (2).
  4. Install the power steering fluid reservoir bracket bolts (1).

    5. Tighten
    Tighten the bolts to 9 N·m (8 lb in).

  5. Install the radiator inlet hose to the water outlet. Refer to Radiator Inlet Hose Replacement .
  6. Install the engine mount strut bracket. Refer to Engine Mount Strut Bracket Replacement - Right Side .