2008 Mid-Model Intermediate Drive Shaft (IDS) Seal Update
The IDS seal design was updated in the mid-model year 2008 Getrag 760/790 Transfer Cases.
Replacing the IDS seal with the correct seal requires identification between first and second design transfer cases. Refer to the table below.
Seal Design Usage | First Design | Second Design |
|---|---|---|
Transfer Case P/N | 24244527 | 24246213 |
Original IDS Seal P/N | 19132951 / 19178698 | 19206322 |
Original Seal Color | Yellow or Blue | Green |
Replacement Service Seal | 19180998 | 19206322 |
Replacement Service Seal Color | Green | Green |
VIN Breakpoint - 12/19/2007 | -- | 1GKEV23788J217964 |
IDS Seal Identification
First design, pre-breakpoint seals were built with IDS seals that have yellow or blue shaft guides and are replaced with unique, short neck seals (1) with a green shaft guide.
Second design, post-breakpoint seals were built with IDS seals that have green shaft guides (1) and are serviced with unique, long neck seals (2) with green shaft guides.
Seal Design
Second design IDS seals have sealing lips extended about 5 mm (0.20 in) from the first design sealing location.
Second design IDS seals are not compatible with first design transfer cases. Installing a second design seal in a first design transfer case will create a transmission fluid leak due to interference with the input shaft.
Seal Installation
Installing the replacement seal to the proper depth is critical. Use DT-48078 Inner Drive Shaft Seal installer with J 8092 Driver Handle to install the seal 2.8 mm (0.11 in) (a) from the end of the input shaft. Refer to Front Drive Axle Inner Shaft Seal Replacement .
