For 1990-2009 cars only
Diagnostic Instructions
| • | Perform the Diagnostic System Check - Vehicle prior to using this diagnostic procedure. |
| • | Review Strategy Based Diagnosis for an overview of the diagnostic approach. |
| • | Diagnostic Procedure Instructions provides an overview of each diagnostic category. |
DTC Descriptor
DTC B0005 00: In Park Switch CircuitCircuit/System Description
The body control module (BCM) supplies the park enable signal circuit voltage when the vehicle transmission is in Park.
Conditions for Running the DTC
The system voltage is between 9-16 volts.
Conditions for Setting the DTC
The BCM detects there is a short to ground for greater than 5 seconds.
Action Taken When the DTC Sets
The BCM will not supply voltage to the circuit.
Conditions for Clearing the DTC
| • | The current DTC will clear when the malfunction is no longer present. |
| • | A history DTC clears when the module ignition cycle counter reaches the reset threshold of 50, without a repeat of the malfunction. |
Reference Information
Schematic Reference
Body Control System Schematics
Connector End View Reference
Electrical Information Reference
Scan Tool Reference
Control Module References for Scan Tool Information
Circuit/System Testing
- Ignition OFF, disconnect the X5 harness connector at the BCM.
- Verify there is no aftermarket component wired to terminal 19.
- If all circuits test normal, replace the BCM.
| ⇒ | If there is an aftermarket component wire, test the circuit terminal for a short to ground. If the circuit tests normal, replace the BCM. |
Repair Instructions
Perform the Diagnostic Repair Verification after completing the diagnostic procedure.
| • | Control Module References for module replacement, setup, and programming |
