GM Service Manual Online
For 1990-2009 cars only
Makes
🢒
Buick
🢒
2009
🢒
Enclave
🢒
Engine
🢒
Engine Mechanical - 2.8L, 3.0L, 3.2L, or 3.6L
🢒 Power Steering Pump Replacement
Removal Procedure
Remove the fuel injector sight shield. Refer to
Fuel Injector Sight Shield Replacement
.
Remove as much power steering fluid from the remote power steering fluid reservoir as possible.
Place drain pans under the vehicle as needed.
Remove the drive belt. Refer to
Drive Belt Replacement
.
Remove the steering gear heat shield. Refer to
Steering Gear Heat Shield Replacement
.
Remove the right side catalytic convertor. Refer to
Catalytic Converter Replacement - Right Side
.
Disconnect the power steering fluid reservoir outlet hose (1) from the power steering pump.
Disconnect the power steering gear inlet hose (1) from the power steering pump.
Remove the power steering pump bolts (2).
Remove the power steering pump (1) from the vehicle.
Transfer any parts as needed.
Installation Procedure
Install the power steering pump (1) to the vehicle.
Caution:
Refer to
Fastener Caution
in the Preface section.
Install the power steering pump bolts (2) and tighten to
50 N·m (37 lb ft)
.
Connect the power steering gear inlet hose fitting (1) to the power steering pump and tighten to
27 N·m (20 lb ft)
.
Connect the power steering fluid reservoir outlet hose (1) to the power steering pump.
Clean any excess fluid from the vehicle and remove the drain pans.
Install the right side catalytic convertor. Refer to
Catalytic Converter Replacement - Right Side
.
Install the steering gear heat shield. Refer to
Steering Gear Heat Shield Replacement
.
Install the drive belt. Refer to
Drive Belt Replacement
.
Fill and bleed the power steering system. Refer to
Power Steering System Bleeding
.
Install the fuel injector sight shield. Refer to
Fuel Injector Sight Shield Replacement
.